WE67K Bending machine is the application of the equipment of the mold (general or special mold) will be cold metal sheet bending into a variety of geometric section shape of the workpiece,
bending machine is generally used bending machine special NUMERICAL control system, the axis of the bending machine has been developed from single axis to 12 axis,
The numerical control system can automatically complete the sliding block running depth control, sliding block left and right tilt adjustment,
rear stopper before and after adjustment, left and right adjustment, pressure tonnage adjustment and sliding block approaching speed adjustment and so on.
1. First, switch on the power supply, turn on the switch on the control panel, and then start the oil pump, so that you can hear the rotation of the oil pump, but the opportunity device does not perform the action.
2, the use of travel conditioning, must pay attention to the use of travel conditioning, before bending to test. It is necessary to ensure that there is a plate thickness gap when the upper die goes down to the bottom, otherwise it will cause damage to the mold machine, and the adjustment of the stroke is also made by electric rapid adjustment.
3, bending notch selection, generally choose the plate thickness of 8 times the width of the notch. For bending 4mm sheet metal, choose about 32 notches.
4, rear stopper adjustment is generally electric quick adjustment and manual fine tuning, the same as the shearing machine.
5, step on the foot switch beginning bending, CNC bending machine mold and shearing machine is different, can loosen at any time, loosen the foot will stop, continue to step down
