press brake machine

The press brake machine hydraulic  mould is an important part of the operation of the bending machine. Take a look at the six common measurement parameters of the bending machine mould: 1. The degree of conformity between the arc on the mold circle of the bending machine and the outer diameter of the pipe to be bent. 2. Whether the low warp of the circular arc on the mold circle of the bending machine conforms to the radian required by… Read More »The press brake machine hydraulic mould is an important part of the operation of the bending machine.

Bending machine price  Main configuration (optional) : 1. The piston of the main cylinder of the machine tool adopts aerospace technology - surface nickel and phosphorus treatment, its hardness can reach HRC60 above, and the guide sleeve relative to the piston adopts the self-lubricating zinc-based wear-resistant alloy, which can make the cylinder in a good working state for a long time. 2, the use of torsional shaft synchronization, mechanical block, reliable, economic, high precision. 3. The upper die is equipped… Read More »Maanshan Durmapress Machinery Technology Co.,Ltd Bending machine price concessions, quality assurance.

W12 series four roll plate rolling machine 1. Adopting the unique torsional shaft synchronous structure in China, high precision and good roundness after coiling! (Previous models slide guide, slide way easy to be worn by iron filings, affecting the accuracy and service life of the machine) 2. Full hydraulic motor drive, environmental protection and energy saving. 3. Short straight edge, good pre-bending effect! It is more suitable for rolling tapered cylinders. 4. The plate winding process only needs one pass… Read More »W12 series four roll plate rolling machine-high precision and good roundness after coiling!

WC67Y-40T/2500 hydraulic bending machine structure characteristics: Slider part: hydraulic transmission, slider part is composed of slider, cylinder and mechanical stopper fine tuning structure. The left and right cylinder is fixed on the frame, the piston (rod) drives the slider up and down through the hydraulic pressure, and the mechanical block is controlled by the numerical control system to adjust the numerical value; Worktable part: by the button box operation, the motor drive the block frame move before and after, and… Read More »WC67Y-40T/2500 hydraulic bending machine structure characteristics

A brief introduction to WC67Y-40/2500 hydraulic bending machine WC67Y-40/2500 hydraulic bending machine is a kind of widely used plate bending equipment,with a very simple general mold for plate bending a variety of angles of the straight line, simple operation, good versatility, low mold cost, convenient replacement, the machine itself only one basic movement -- up and down reciprocating straight line movement. Two, the main structure and working principle of WC67Y-40/2500 hydraulic bending machine: 1. Main structure of the machine The… Read More »A brief introduction to WC67Y-40/2500 hydraulic bending machine

During the first test run, the electric unit of oil pump should be started for empty operation first, and then the movement of the nc hydraulic press brake should be tested by "inching". Then test the "single" and "continuous" movements, the sliding block stroke and the rear stopper control functions. When the machine is proved to be in normal operation, the following procedures can be followed. 1. According to the thickness of the plate and the length of the folded… Read More »Precautions and operation steps of nc hydraulic press brake before test run