Imported hydraulic system with compact structure, ball screw can be used for rear stopper, and synchronous belt drive can be used for stable performance according to user requirements.
Safe operation rules of bending machine:
Wear labor protection equipment according to the regulations and strictly abide by the safe operation rules of machine tool workers.
Check that the control parts and buttons of the equipment are stuck in the correct position. Before starting the small bending machine, it is necessary to carefully check whether the motor, switch, circuit and grounding are normal and firm.
Check the overlap and firmness of the upper and lower die to check whether the positioning device meets the requirements of the processing.
When the sliding plate and each positioning shaft are not in the state of the origin when the bending machine runs back to the origin program.
The skateboard moves for 23 times in full stroke, and the equipment runs for 12 minutes after starting. If there is abnormal sound or trouble should be immediately stopped, the trouble will be removed, all normal before the work.
Make the operator closely cooperate with the feeding and pressing personnel, and the work should be commanded by one person. Ensure that all the cooperating personnel are in a safe position before sending out the bending signal.
The sheet must be compacted when bending to prevent the sheet from warping and wounding.
The power supply must be cut off when adjusting the sheet material pressing die after stopping operation.
Do not allow any material contact with the lower die. Change the opening of the variable lower die.
No one is allowed to stand at the back of the machine when it is working.
It is strictly prohibited to press and fold sheet material at one end.
English 
Russian 
Spanish 