Nc bending machine mold installation and debugging
CNC bending machine mould must be installed and debugger before use, which is two very important links.
Do a good job to make the bending machine mold -- work, the following are the key points to CNC bending machine mold installation and debugging.
First, before the installation of the equipment, first adjust the performance of the equipment,
carefully check the equipment, see if there is no dust or used iron filings and other factors affecting the work of the equipment.
Two, the slider stroke adjustment should pay attention to see whether the thickness of the mold meets the requirements,
and whether the proportion of the upper and lower molds is normal.
Three, stroke module adjustment, adjust the upper limit point.
In addition, but also to adjust the CNC bending machine mold Angle, gap and so on, only according to the requirements of each step,
then can - the equipment can operate normally and effectively.
Improper operation is easy to affect the use of equipment, but also damage the equipment,
zhongshan bending machine mold, so we must pay attention to the installation and debugging of equipment.