1, strictly abide by the machine tool operation rules, wear labor protection equipment according to the provisions;
2, before the boot should be on the mold, under the production model tidy up, cleaning, the slot shall not be iron Hazi what foreign body,
otherwise destroy the production model, affect the correctness of the work hydraulic sheet bending machine.
Before starting carefully check whether the motor, switch, line and grounding is normal and firm, check the operating parts of hydraulic sheet bending machine,
buttons are stuck in the correct position; Check whether there are foreign bodies on the front supporting frame,
rear retaining frame and slide block. If there are foreign bodies, they should be tidy and tidy, otherwise it is easy to become a safety hazard;
Check the consistency and firmness of the upper and lower molds; Check whether the positioning device is in line with the processing requirements.
3. When the upper slide plate and each positioning axis are not at the origin, run the program of returning to the origin.
4. After the equipment is started, it will run for 1-2 minutes, and the skateboard will move 2-3 times in full journey.
If there is abnormal sound or fault, it should stop immediately, remove the fault, and then work normally.
5. Before machine protection or cleaning, the upper die should be aligned with the lower die and then put down and shut down until the end of the operation.
If it is necessary to start up or other operations, the form should be selected manually.
Check the oil level of the oil tank every week for the hydraulic oil circuit. If the oil level is lower than the oil window, add hydraulic oil.
6, every time the filter oil change, the filter should be replaced or removed;
The machine tool has related alarm or oil unclean and other abnormal filter, should be replaced;
The air filter on the tank is checked and cleared every 3 months and replaced every 1 year.