1. Before installation, according to the installation requirements of ground wire in the manual,
the ground wire is reliably connected with the ground point of the equipment high quality hydraulic press brake.
Electricity for inkjet printer and vacuum pump system are provided only high quality hydraulic press brake.
2. Due to the long-term transportation of the equipment, it may cause the loosening of screws in all parts of the power distribution cabinet of the bending machine, leading to the virtual connection of the line.
It is recommended to tighten screws in all parts of the power distribution cabinet before the installation
of the equipment to ensure the stability and reliability of the line connection.
3, the use of 220V AC voltage, working power supply 3KVA installed capacity, before the power supply of the bending machine,
to detect the household power supply and wire diameter to meet the requirements of the equipment,
equipment line whether there is a short circuit phenomenon, after the exclusion of short circuit phenomenon can be energized.
4, before power should carefully check each switch such as air switch, ship switch, whether the rotation is flexible, contact is good, appearance is not damaged and other phenomena.
5. After ensuring the above points are correct, power on the power supply system of the bending machine and observe whether the car is normal for self-inspection; The status indication of each main device is normal; Check whether the voltage on the output end of the power module and the end of the transmission line meets the requirements.
When checking the line of the bending machine, we must not randomly remove a wire,
otherwise it will increase the fault that should not occur. When wiring, we must check whether the line is loose and the contact is good.
