The friction parts of the three-roller rolling machine mechanical symmetrical bending machine must always keep good lubrication

The friction parts of the three-roller rolling machine mechanical symmetrical bending machine must always keep good lubrication, the lubrication requirements of the components of the three-roller mechanical symmetrical bending machine are as follows:

1. Upper roller journal lubrication, oil condition liquid injection. The oil cup is placed on the top of the fixed end of the upper roller hinge seat.

Before starting each shift, the mechanical oil is injected into the oil until it flows into both sides and spills over.

After the movable end is pulled down and overturned, the middle of the half pin shaft hole of the square shaft seat has an oil hole,

so the mechanical oil is injected three-roller rolling machine.

2. The lower roller's journal lubrication, oil condition, liquid injection, the top of the lower roller seat has an oil cup.

From this until the oil flow from both sides of the journal overflow, injection 3-4 times per shift.

3. Lifting screw lubrication, from the lower roller seat in the middle of the upper end of the screw gun to screw,

so that the oil flow down the screw flow, 3-4 times per shift.

4. Lubrication of worm gear, grease smear, once a month, remove the outer cover of worm gear when refueling, dip grease with a brush, start the worm gear to convey a week, all tooth surface add enough grease. Transmission gear lubrication is the same.

5. Gear oil is added in the reducer and replaced every six months.