Talk about press brake da52s after the distance tool how to adjust

Ordinary press brake da52s very affect the production efficiency, but also can not meet the existing products required accuracy;

If a new CNC bending machine cost is relatively high at the same time ordinary press brake da52s  idle is also a waste.

Thus improve the production efficiency of the bending machine, improve the bending accuracy, and greatly save the cost.

Technical requirements:

1. Electrical part: NUMERICAL control system: add NUMERICAL control system E210 + suspension arm.

Servo system: replace the original common three-phase asynchronous motor drive with servo drive motor.

Electric control box: add 2 sets of servo drive, circuit breaker and intermediate relay inside the electric box if the original box allows.

Also can reconfigure a small electrical box, will increase the components according to the need to make an independent electrical box,

as long as the electrical box from the power supply, the increase of NUMERICAL control input and output signals

and the new configuration of the electrical box signal can be exchanged.

2. Mechanical part: the servo motor part of the rear stop material is installed to process transition parts

(the installation size of the ordinary motor is different from the size of the ESTUN servo motor that needs to be replaced, so it needs to be reprocessed) to reduce errors.

3, hydraulic system: retain the original hydraulic system, the newly added NUMERICAL control system of the original machine tool valve group output control can be flexibly assembled.