Numerical control bending machine manual mode parameter explanation

Numerical control bending machine manual mode parameter explanation

The following parameters can be used in manual mode of CNC bending machine.

1. Thickness: edit the thickness of the sheet.

2. Material 1: cold plate 2: aluminum 3: Galvanized plate 4: stainless steel plate 5: custom plate 6: Custom plate

3. Bending mode: Select the required bending mode. The system supports 4 bending modes

4. Bending length: the length of the sheet bent by programming.

5. Y-axis: The Y-axis value programmed or calculated for a certain Angle.

6. Speed transition point: the position of Y axis when it changes from fast down speed to working speed. It's set here to a y-position value. Edit value for Y axis position higher than bending sheet.

7. Parallelism Difference between left and right cylinders (Y1, Y2). When this parameter is positive, the right cylinder is lower than the left cylinder; When this parameter is negative, the right cylinder is higher than the left cylinder. The set value is valid below the clamping point.

8. Opening: after bending, there is a certain gap opening between the upper die and the lower die. A positive value indicates that the gap opening is above the velocity transition point, while a negative value indicates that the gap opening is below the velocity transition point. When users want to limit the processing time of an artifact, they can set a small positive or negative value.

9. Waiting for concession: If concession occurs, you need to choose whether to make Y-axis wait until the concession operation is completed. 0= no: in concession,Y axis does not wait for concession in place, directly down; 1= Yes: During concession, the Y-axis waits for concession to be in place before the slider comes down.

10. CNC bending machine mold: select the name of the upper mold (ID), click the related mold in the upper mold library to select or modify.

11. CNC bending machine lower die: Select the name of the lower die (ID), click select or modify in the lower die library.

12. Yield: the yield distance of the shaft in the process of bending, and the stopper begins to yield at the clamping point.