Metal laser cutting machine heat dissipation system cleaning work is we in the usual use of the
process - must not be a part of the neglect,
I hope we do not ignore. If you do not know how to clean before, you can take a look
at the details of the following article, as after looking at the know.
The heat dissipation system of metal laser cutting machine as the main heat dissipation channel of cutting torch,
can be divided into two categories of air-cooled heat dissipation and water-cooled heat dissipation in conventional configuration.
Plasma is a special form of matter, which is listed as the fourth state of matter after solid, liquid and gas in modern physics.
Plasma arc is a kind of compressed arc which is obtained by forcing the free arc through mechanical compression,
thermal compression and magnetic contraction. It has concentrated energy, high temperature (arc center temperature 18000-24000K) and
high flame velocity (more than 300m/s). This paper will be mainly on the metal laser cutting machine heat dissipation system
cleaning and daily maintenance to pay attention to some requirements are summarized and explained:
1. Remove the screw, remove the air filter, and prepare for cleaning;
2. Monitor the power grid voltage of CNC system regularly to ensure that the fluctuation range of power grid voltage is within the allowed rated range;
3. Gently vibrate the removed filter, and at the same time, blow off the dust in the air filter with compressed air from inside to outside;
4. Check and replace dc motor brush regularly;
5. If the filter dust is too thick and compressed, it can be washed gently with neutral detergent and dried in a cool place;
6. Replace storage batteries regularly. In general, the battery should be replaced once a year,
even if it has not failed, to ensure that the system can work properly.
These are the specific cleaning methods of the metal laser cutting machine heat dissipation system,
I believe that you can clearly see how to clean him after reading.
