The specific method of installing Jude bending machine mold on the durmapress punch press is as follows:
1) Before installation, check whether the edge of the mold is sharp, whether there is a collapse, whether the punch is missing Angle.
Problems should be dealt with in a timely manner durmapress punch press.
2) Before closing the mold, a silicon steel sheet should be placed between the
upper and lower molds to prevent scratches during handling.
3) Before the bending machine mold of Jude company is ready to be loaded on the punch press,
the burrs on the bottom surface and above should be ground off with an oil stone, and the garbage will be removed with
a clean cotton cloth. If not handled well will lead to punching burr out of tolerance.
4) Adjust the stroke of the slide block to an appropriate position to press the upper die,
ensure that the die handle or die frame plane is closely attached to the bottom of the slide block,
and the screw of the lower die plate is gently pressed. Then, adjust the slider upward to remove the silicon steel sheet in the middle.
Loosen the screw of the lower die pressing plate, adjust the slider downward until the punch enters the concave die 3 ~ 4mm,
press the screw of the lower die pressing plate. New die punching punch must enter the die 3 ~ 4mm,
otherwise, there will be punch collapse or die swell crack.
5) Raise the top dead point of the slider, adjust the ejector screw of Jude punch press,
and then idle several times to check whether the bending machine die and all parts of the punch press work normally.
