CNC bending machine can automatically adjust the slider levelness, including the slider, the hydraulic cylinder driving the slider and the controller,
the sensor set on both sides of the slider, the position sensor is connected to the controller. The position sensor is a grating ruler,
the fixed ruler is connected to the body, and the moving ruler is connected to the slider.
Both sides of the slide block can ensure that the slide block in the occurrence of levelness error timely forecast and read the data,
and through the controller timely instruction one side or two sides of the power hydraulic cylinder to do micro adjustment,
to ensure that the reading measured by the grating ruler meets the design requirements, so as to effectively ensure the levelness of the knife edge.
The parts of the bending machine include synchronous system, slider part, retaining mechanism and table part, etc.
The synchronous system here is composed of torsion shaft, swing arm, joint bearings and other parts, the overall structure is simple,
stable and reliable performance, high synchronization accuracy.
In the bending machine is the use of hydraulic transmission, so its slide block part by the slide block, oil cylinder and mechanical block fine-tuning structure;
The left and right cylinders of the bending machine are fixed on the frame, and the piston drives the slide block to move up and down through hydraulic pressure.
The mechanical block is controlled and adjusted by the NUMERICAL control system.
