2000w Fiber laser cutting machine in the use of the process will appear cutting sheet metal material gap is too wide, encountered this common problem how to deal with it?
We can start from the following three aspects.
1, the operation engineer should first check the focal length of the optical 2000w fiber laser machine for metal cutting , check whether the focal length is correct, find errors to adjust in time.
At the same time, it should be noted that the way to adjust the focal length is divided into manual and automatic.
Manual focusing is easy to be forgotten. After replacing or cleaning the lens, the operation engineer should carefully check the focal length.
2, the focal length is no problem, you can check the lens, big kerf width is also can check the lens in the optical fiber laser cutting machine and avoid,
if the surface of the lens are a dirty also affects the material cutting, no lens clean easy to light scattering, and became thicker, so check the lens and clean or replace is a good choice;
3, the placement of the laser tube is also a very important aspect, if the light spot or spot is not round, it may be the laser tube support point needs to be adjusted,
many people will ignore this reason, which also need to pay attention to.
In the use of optical fiber laser cutting machine will inevitably be in the process of some error, and this requires customers to do
well in usual optical fiber laser cutting machine maintenance, thus lengthening maximum working time limit of optical fiber laser
cutting machine equipment, to create greater value, any problem at the same time also can directly contact manufacturer to solve the problem.
