1. Comply with general cutting machine safety procedures. Start the laser in strict accordance with the laser starting procedure.CNC laser cutting machine
2. The operator must be trained, familiar with the structure and performance of the equipment, and master the knowledge of the operating system.
3. Wear labor protection equipment according to the provisions, and wear protective glasses in accordance with the provisions near the laser beam.
4. Do not process a material until it is clear whether it can be lasered or heated to avoid the potential hazard of smoke and steam.
5. When the equipment starts, the operator shall not leave the post without authorization or ask someone to take care of it. If it is necessary to leave, the machine shall be shut down or the power switch shall be cut off.
6. Keep fire extinguishers within easy reach. Do not process to turn off the laser or light brake; Do not place paper, cloth or other flammable objects near unprotected laser beams.
7. In the process of processing found abnormal, should immediately stop, timely troubleshooting or report to the supervisor.
8. Keep the laser, bed and the surrounding area clean, orderly and free from oil pollution, and pile up the workpiece, plate and waste materials as required.
9. When using gas cylinders, avoid crushing welding wires to avoid electric leakage accidents. The use and transportation of gas cylinders shall comply with the supervision regulations of gas cylinders.Do not burst cylinders in the sun or near heat sources. The operator must stand on the side of the bottle when opening the valve.
10. High pressure safety regulations should be observed during maintenance. Maintenance per 40 hours of operation or weekly, 1000 hours of operation or every six months shall be carried out in accordance with rules and procedures.
11. After starting the machine, manually start the machine at low speed X and Y direction to check and confirm whether there is any abnormal situation.
