What are the safe operating procedures of CNC bending machine? The following future specific introduction.
(1) the operator should wear good labor protection equipment,
and operate the CNC bending machine in accordance with the operating procedures and other provisions.
(2) Before starting the machine, check the motor, switch and circuit, etc.,
whether the machine and equipment are reliably grounded, and whether the switch button is in the correct position.
(3) after the completion of the work, to cut off the CNC bending machine source, and do a good job of shift work.
(4) After the machine and equipment are started, it should run for 1 to 2 minutes without any problems before it starts to work.
(5) In the process of operation, if the workpiece or mold position is found to be offset,
it should be stopped immediately for correction, can not be corrected by hand.
(6) when the plate is bent, it should be compacted to prevent the plate from warping.
Do not bend the sheet at one end.
(7) when the CNC bending machine works, it should be under the unified command of a special person,
and all parts of the staff should cooperate closely and follow the arrangement and command.
(8) can not be super performance bending, so as not to damage the bending machine.
(9) CNC bending machine once abnormal, so it should immediately stop inspection, and to eliminate in time.
(10) the coincidence degree and firmness of the upper and lower die should be checked to see if the positioning device can work normally.
