How to program CNC bending machine
1. First, switch on the power supply, turn on the switch on the control panel, and then start the oil pump, so that you can hear the sound of the oil pump. (The machine does not act at this time)
2, travel adjustment, use must pay attention to adjust the travel, must be tested before bending. Its upper die must be guaranteed to have a plate thickness clearance when running down to the bottom. Otherwise, it will cause damage to the mold machine. The adjustment of the stroke is also a quick electric adjustment.
3, bending groove selection, generally choose the plate thickness of 8 times the width of the notch. Such as bending 4mm sheet material, need to choose about 32 notch. 4, the rear stopper adjustment is generally electric rapid adjustment and manual fine tuning, the method is the same as the plate shearing machine.
5, step down the foot switch to start bending, CNC bending machine mold and shearing machine is different, can be released at any time, loosen the foot will stop, continue to step down.
