Knowledge

1. BS3015T-3000W Laser cutting machine and punching technology Any thermal cutting technique, except in a few cases where it can be started from the edge of the board, generally must have a small hole through the board. Before the laser stamping compound machine is to punch out a hole, and then start cutting from the hole with the laser. There are two basic ways to punch a laser cutter without a stamping device: Blasting perforation - The material is irradiated… Read More »BS3015T-3000W Laser cutting machine common six problems and treatment methods

When the user uses the BS60220T- 3000W fiber laser cutting machine, it is also hoped that it has various requirements for the use of this product, so what are the requirements for the use of this product?

After optical 1500W fiber laser cutting is shut down for a long time, in order to ensure an fully reliable operation of the equipment, extend the service time, and avoid unnecessary trouble caused by irregular startup for future use, the following steps should be followed before startup.   1. Start the main power supply and the voltage regulator power supply (before starting the power supply, check whether all lines are damaged or have poor contact)   2. Switch on the… Read More »Precautions for starting the 1500W fiber laser cutting machine