1kw fiber laser cutting machine is the core equipment of fiber laser cutting machine.
One of the main reasons for the failure of the fiber laser power supply is the internal condensation of the laser.
The internal condensation of the fiber laser is very related to the daily bad habits of the customer operation using the fiber laser.
In order to reduce the failure rate of the fiber laser and reduce the loss caused by the shutdown of the fiber laser cutting machine to customers,
attention should be paid to the use of the fiber laser cutting machine.
1kw fiber laser cutting machine boot sequence
1. Check whether there are items affecting the safe operation of the machine within the operating range;
2. Turn on the general power switch of the fiber laser cutting machine and the control power switch of each branch;
3. Open the voltage regulator, check whether the running state of the voltage regulator is normal;
4. Turn on the power switch of the fiber laser, and then turn on the key switch to enable the air
conditioner or internal dehumidifier of the fiber laser to run for more than 30 minutes.
5. Turn on the air compressor when the power switch of the fiber laser runs for 20 minutes,
and check whether the operation status of the air compressor is normal;
6. Open the air control valve, open the cold dry machine, check whether the operation state
of the cold dry machine is normal, whether the air pressure is normal;
7. According to the cutting needs, open the cutting auxiliary gas control valve, check whether the cutting auxiliary gas pressure is normal;
